Here is a link to my eBay store if you would like to buy the items:
https://www.ebay.com/itm/DIY-Mini-Keg-System-5L-Kegs-Homebrew-Beer-Force-Carbonation/232750991082
List of items:
• (2) ¼ inch Nipples
• Rubber Bung
• ¼ inch Copper Tubing – 2 feet
• 3/8 X ¼ Brass Compression Adapter
• ¼ inch Male X 3/8 inch Hose Barb
Optional
• Easy turn hose clamp for 3/8 inch tubing
• Easy turn hose clamp for ¼ inch tubing
• ¼ inch Party Tap
• ¼ inch Keg line tubing – 4 feet
• 3/8 inch Keg line tubing – 4 feet
First scene shows the Mini Keg System all set up and how it works.
1. Co2 goes through the regulator and into the Hose Barb.
2. From the Hose Barb the co2 goes into the Threaded Tee.
3. Co2 inside the threaded Tee will try to leave out both sides but the compression adapter will stop it from going up and force it down into the keg.
4. With no where else to go the Co2 travels down the threaded Tee through the Nipple, around the copper tubing and into the keg.
5. The Gray Rubber bung creates a seal at the top of the keg.
6. Once the Co2 is inside the keg the air tight seal produced with the compression adapter will trap the Co2 inside the keg causing force carbonation.
7. Inside the Compression adapter is a ¼ inch copper tube which runs down the nipple, through the threaded tee, through the other nipple and to the bottom of the keg.
8. At the top of the system the end of the copper tube sticks out through the Compression Adapter where ¼ inch Keg Line tubbing is connected. Using a Hose clamp that creates an air tight seal.
9. On the other end of the ¼ inch keg line tubbing is a Party Tap also with a hose clamp.
10. The whole system is air tight which causes pressure to build inside the keg. Once the pressure is released by opening the party tap the beer will flow freely.
Second scene shows an aerial shot of the items on a white sheet of paper with pieces of paper showing the name of each individual piece.
List of items:
• (2) ¼ inch Nipples
• Rubber Bung
• ¼ inch Copper Tubing – 2 feet
• 3/8 X ¼ Brass Compression Adapter
• ¼ inch Male X 3/8 inch Hose Barb
• Easy turn hose clamp for 3/8 inch tubing
• Easy turn hose clamp for ¼ inch tubing
• ¼ inch Party Tap
• ¼ inch Keg line tubing – 4 feet
• 3/8 inch Keg line tubing – 4 feet
Link to parts on eBay: https://www.ebay.com/itm/DIY-Mini-Keg-System-5L-Kegs-Homebrew-Beer-Force-Carbonation/232671743634